Seal-Crankshaft Oil Front

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Crankshaft Sprocket Dowel Pin

Courtesy of CHRYSLER LLC

1 - PIN PUNCH

2 - DOWEL

Remove the crankshaft sprocket. See REMOVAL .
Tap the dowel pin (2) out of the crankshaft. See Fig 1.

Fig 2: Removing Crankshaft Oil Seal With Special Tool 6341A
Courtesy of CHRYSLER LLC

1 - SPECIAL TOOL 6341A
Remove crankshaft seal using Tool 6341A (1). See Fig 2.
CAUTION: Do not nick shaft seal surface or seal bore.
Shaft seal lip surface must be free of varnish, dirt or nicks. Polish with 400 grit paper if necessary.