Damper - Crankshaft: Installation: Damper-Crankshaft

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Crankshaft Damper

Courtesy of CHRYSLER LLC

1 - SPECIAL TOOL 6792-1

2 - SPECIAL TOOL C-4685-C1

Install crankshaft damper using Special Tools C-4685-C1 (5.9 in.) Bolt, with Nut and Thrust Bearing from 6792, and 6792-1 Installer. See Fig 1.

Fig 2: Damper Holder
Courtesy of CHRYSLER LLC
Install crankshaft damper bolt. Torque bolt to 95 N.m (70 ft. lbs.) while holding damper with Special Tool 9365.

Lower vehicle.

Fig 3: Identifying Serpentine Accessory Drive Belt

Courtesy of CHRYSLER LLC

1 - DRIVE BELT TENSIONER

2 - POWER STEERING PULLEY

3 - AIR CONDITIONING COMPRESSOR

4 - CRANKSHAFT DAMPER

5 - GENERATOR

6 - DRIVE BELT

Install accessory drive belt. See Fig 3.
Connect negative battery cable.