LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (2.7L Engine (Service Information)) >> Valve Timing >> Chain And Sprockets-Timing >> Removal >> Sprocket-Crankshaft

Chain And Sprockets-Timing: Removal: Sprocket-Crankshaft

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing Crankshaft Sprocket
GC0015388Courtesy of CHRYSLER LLC
  1. Remove primary timing chain. See REMOVAL .
    CAUTION: Use care not to turn crankshaft while removing crankshaft sprocket, as damage to valves and or pistons could occur.
  2. Remove crankshaft sprocket by first installing the crankshaft damper bolt. Apply grease or equivalent to damper bolt head and position Special Tools 5048-1(3), 5048-6 (2), and 8539 (1) on sprocket and crankshaft nose. Remove sprocket using care not to rotate the crankshaft.
scientia non olet · About LEMON Manuals