LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (2.7L Engine (Service Information)) >> Manifolds >> Manifold-Exhaust >> Removal >> Manifold-Exhaust Left- Removal

Manifold-Exhaust Left- Removal

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Battery
GC0015222Courtesy of CHRYSLER LLC
  1. Disconnect negative battery (1) cable located in trunk.
    Fig 2: Air Cleaner Housing
    GC0015232Courtesy of CHRYSLER LLC
  2. Disconnect intake air temperature sensor connector.
  3. Remove air cleaner housing assembly (3). See REMOVAL .
  4. Remove oil dipstick tube (4).
    Fig 3: Left Exhaust Manifold
    GC0015376Courtesy of CHRYSLER LLC
  5. Disconnect and remove oxygen sensor (2).
  6. Remove upper heat shield (1) and lower heat shield (4).
  7. Raise vehicle on hoist.
  8. Disconnect down stream oxygen sensor connector.
  9. Remove exhaust pipe from manifold. Refer to REMOVAL .
  10. Remove exhaust manifold attaching bolts and remove manifold.
scientia non olet · About LEMON Manuals