LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (2.7L Engine (Service Information)) >> Manifolds >> Manifold-Exhaust >> Installation >> Manifold-Exhaust Right- Installation

Manifold-Exhaust Right- Installation

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Right Exhaust Manifold
GC0015377Courtesy of CHRYSLER LLC
  1. Install exhaust manifold gasket and manifold (4). Tighten bolts working from center outwards to 23 N.m (200 in. lbs.).
  2. Install exhaust pipe to manifold. Refer to INSTALLATION .
  3. Install lower heat shield (3) and upper heat shield (2).
  4. Install oxygen sensor (5) and connect electrical connector.
  5. Connect down stream oxygen sensor electrical connector.
  6. Lower vehicle.
  7. Install EGR tube (1) using new gaskets. Tighten screws to 11 N.m (95 in. lbs.).
    Fig 2: Locating Battery
    GC0015222Courtesy of CHRYSLER LLC
  8. Connect negative battery (1) cable.
scientia non olet · About LEMON Manuals