LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (2.7L Engine (Service Information)) >> Manifolds >> Manifold-Exhaust >> Installation >> Manifold-Exhaust Left - Installation

Manifold-Exhaust Left - Installation

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Battery
GC0015222Courtesy of CHRYSLER LLC
  1. Disconnect negative battery (1) cable.
    Fig 2: Exhaust Manifold
    GC0015378Courtesy of CHRYSLER LLC
  2. Raise vehicle on hoist.
  3. Install exhaust manifold gasket (3) and manifold (4). Tighten bolts starting at the center working outward to 23 N.m (200 in. lbs.).
  4. Instal manifold lower heat shield (6) and upper heat shield (1). Tighten fasteners to 28 N.m (250 in. lbs.).
  5. Install exhaust pipes to manifolds. Refer to INSTALLATION .
  6. Connect down stream oxygen sensor connectors.
  7. Lower vehicle.
    Fig 3: Left Exhaust Manifold
    GC0015376Courtesy of CHRYSLER LLC
  8. Install oxygen sensor (2) and connect electrical connector.
    Fig 4: Locating Battery
    GC0015222Courtesy of CHRYSLER LLC
  9. Connect negative battery (1) cable.
scientia non olet · About LEMON Manuals