Section 241 (2.7L Engine (Service Information)): Lubrication: Pan-Oil: Removal: Pan-Oil

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Battery

Courtesy of CHRYSLER LLC

Disconnect negative battery cable (1) located in trunk.

Fig 2: Air Cleaner Housing
Courtesy of CHRYSLER LLC
Remove engine oil indicator (4).
Raise vehicle on hoist.

Fig 3: Lower Splash Shield
Courtesy of CHRYSLER LLC
Remove lower splash shield retaining bolts (1) and splash shield (2).

Fig 4: Locating Engine Mount Bolts, Drain Plug And Filter
Courtesy of CHRYSLER LLC
Drain engine oil (5) and remove oil filter (3).

Fig 5: Steering Knuckle
Courtesy of CHRYSLER LLC
Remove the steering coupler bolt (4) and separate coupler (1) from rack (3).

Fig 6: Electrical Connector
Courtesy of CHRYSLER LLC
Disconnect power steering pressure switch electrical connector (1).

Fig 7: Gear Mounting Bolts
Courtesy of CHRYSLER LLC
Remove steering rack mounting bolts (1).

Fig 8: Power Steering Line Support
Courtesy of CHRYSLER LLC
Remove power steering line support (2) from frame.
Reposition rack out of the way.
Remove structural collar. See REMOVAL .

Fig 9: Alt & A/C Bolts
Courtesy of CHRYSLER LLC
Remove mounting bracket to oil pan lower bolt (1).
Remove A/C compressor bracket to oil pan lower bolt (2).

Fig 10: Front Cover Bolts
Courtesy of CHRYSLER LLC
Remove lower timing chain cover to oil pan bolts (1). See Fig 10.
CAUTION: Assure removal of the four lower timing cover bolts, as damage to the timing cover and/or oil pan may occur.
Remove oil pan and gasket.