LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (2.7L Engine (Service Information)) >> Cylinder Head >> Springs-Valve >> Installation >> Valve Springs (In-Vehicle)

Valve Springs (In-Vehicle)

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Exploded View Of Cylinder Head Components
GC0015273Courtesy of CHRYSLER LLC
  1. The valve stem seal/valve spring seat (4) should be pushed firmly and squarely over the valve guide using the valve stem as guide. Do Not Force  seal against top of guide. When installing the valve retainer locks (1), compress the spring (3) only enough  to install locks (1).
  2. Follow the same procedure on the remaining cylinders using the firing sequence 1-2-3-4-5-6. Make sure piston is at TDC on the cylinder that the valve spring is to be removed. 
  3. Remove spark plug adapter tool and Special Tool MD 998772A.
  4. Install rocker arm(s). See INSTALLATION .
  5. Install camshafts. See INSTALLATION . Install timing chain. See INSTALLATION . Install timing chain cover. See INSTALLATION .
  6. Install cylinder head covers. See INSTALLATION .
    Fig 2: Purge/Intake
    GC0015228Courtesy of CHRYSLER LLC
  7. Install upper intake manifold (1). See INSTALLATION .
    Fig 3: Air Cleaner Housing
    GC0015232Courtesy of CHRYSLER LLC
  8. Install air cleaner housing (3) and inlet hose. See INSTALLATION .
    Fig 4: Locating Battery
    GC0015222Courtesy of CHRYSLER LLC
  9. Connect negative battery (1) cable.
scientia non olet · About LEMON Manuals