LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (2.7L Engine (Service Information)) >> Cylinder Head >> Cover(S)-Cylinder Head >> Removal >> Cylinder Head Cover - Right

Cylinder Head Cover - Right

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Battery
GC0015222Courtesy of CHRYSLER LLC
  1. Disconnect negative battery (1) cable.
    Fig 2: Coil Connectors
    GC0015236Courtesy of CHRYSLER LLC
  2. Remove upper intake manifold. See REMOVAL .
  3. Disconnect electrical connectors from ignition coils (1).
    Fig 3: Capacitor Connector - Right
    GC0015302Courtesy of CHRYSLER LLC
  4. Disconnect capacitor electrical connector (2).
  5. Remove PCV hose from cylinder head cover grommet.
  6. Remove ground strap from cylinder head cover stud (1).
  7. Disconnect electrical harness retaining clips from cylinder head cover studs. Reposition electrical harness.
  8. Remove fastener attaching ignition coil capacitor.
  9. Remove ignition coils.
    Fig 4: Foam Insulator
    GC0015303Courtesy of CHRYSLER LLC
  10. Remove foam insulator (1).
    Fig 5: Cylinder Head Covers
    GC0015300Courtesy of CHRYSLER LLC
  11. Loosen all cylinder head cover fasteners.
    NOTE: Cylinder head cover attaching bolts are captured to the cover.
    CAUTION: Make certain the double ended studs in the center of the cylinder head cover are loose before attempting to remove cover.
  12. Remove cylinder head cover.
scientia non olet · About LEMON Manuals