LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (2.7L Engine (Service Information)) >> Cylinder Head >> Cover(S)-Cylinder Head >> Removal >> Cylinder Head Cover - Left

Cylinder Head Cover - Left

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Locating Battery
GC0015222Courtesy of CHRYSLER LLC
  1. Disconnect negative battery (1) cable located in trunk.
    Fig 2: Coil Connectors
    GC0015236Courtesy of CHRYSLER LLC
  2. Remove upper intake manifold. See REMOVAL .
  3. Disconnect electrical connectors from ignition coils (1).
    Fig 3: Capacitor Connector - Left
    GC0015299Courtesy of CHRYSLER LLC
  4. Remove ground strap from cylinder head cover stud (1) and disconnect capacitor connector (2). Reposition electrical harness.
  5. Disconnect electrical harness retaining clips from cylinder head cover studs. Reposition electrical harness.
    Fig 4: Coil Connectors
    GC0015236Courtesy of CHRYSLER LLC
  6. Remove make up air hose.
  7. Remove fastener attaching ignition coil capacitor.
  8. Remove ignition coils (1).
    Fig 5: Cylinder Head Cover Fasteners
    GC0015297Courtesy of CHRYSLER LLC
  9. Loosen all cylinder head cover fasteners (1)&(2).
    NOTE: Cylinder head cover attaching bolts are captured to the cover.
    CAUTION: Make certain the double ended studs (1) in the center of the cylinder head cover are loose before attempting to remove cover.
  10. Remove cylinder head cover.
scientia non olet · About LEMON Manuals