LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (2.7L Engine (Service Information)) >> Cylinder Head >> Cover(S)-Cylinder Head >> Installation >> Cylinder Head Cover - Right

Cylinder Head Cover - Right

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cylinder Head Cover Gasket & Spark Plug Seals
GC0015298Courtesy of CHRYSLER LLC
  1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gaskets (1)&(2) as necessary.
    Fig 2: Cylinder Head Covers
    GC0015300Courtesy of CHRYSLER LLC
  2. Install cylinder head cover and hand start all fasteners. Verify that all double-ended studs are in the correct locations.
  3. Tighten cylinder head cover attaching bolts and double-ended studs to 12 N.m (105 in. lbs.).
    Fig 3: Coil Connectors
    GC0015236Courtesy of CHRYSLER LLC
  4. Install ignition coils (1).
    Fig 4: Capacitor Connector - Right
    GC0015302Courtesy of CHRYSLER LLC
  5. Install ignition coil capacitor (2) and fastener.
  6. Connect ground strap (1) to cylinder head cover stud.
  7. Connect PCV hose to cylinder head cover grommet.
  8. Connect all electrical connectors and harness clips.
    Fig 5: Foam Insulator
    GC0015303Courtesy of CHRYSLER LLC
  9. Install foam insulator (1) on top of cylinder head cover (2).
  10. Install upper intake manifold. See INSTALLATION .
    Fig 6: Locating Battery
    GC0015222Courtesy of CHRYSLER LLC
  11. Connect negative battery (1) cable.
scientia non olet · About LEMON Manuals