LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (2.7L Engine (Service Information)) >> Cylinder Head >> Cover(S)-Cylinder Head >> Installation >> Cylinder Head Cover - Left

Cylinder Head Cover - Left

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Cylinder Head Cover Gasket & Spark Plug Seals
GC0015298Courtesy of CHRYSLER LLC
  1. Clean cylinder head cover and both sealing surfaces. Inspect and replace gaskets (1)&(2) as necessary.
    Fig 2: Cylinder Head Covers
    GC0015300Courtesy of CHRYSLER LLC
  2. Install cylinder head cover and hand start all fasteners. Verify that all double-ended studs are in the correct locations.
  3. Tighten cylinder head cover attaching bolts and double-ended studs to 12 N.m (105 in. lbs.).
    Fig 3: Coil Connectors
    GC0015236Courtesy of CHRYSLER LLC
  4. Install ignition coils (1).
    Fig 4: Capacitor Connector - Left
    GC0015299Courtesy of CHRYSLER LLC
  5. Install ignition coil capacitor (2) and fastener.
  6. Install ground strap (1) to cylinder head cover stud.
  7. Connect all electrical connectors and harness clips.
  8. Connect make up air hose.
  9. Install upper intake manifold. See INSTALLATION .
    Fig 5: Locating Battery
    GC0015222Courtesy of CHRYSLER LLC
  10. Connect negative battery (1) cable.
scientia non olet · About LEMON Manuals