LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 241 (2.7L Engine (Service Information)) >> Cylinder Head >> Camshaft(S) >> Removal >> Camshaft

Cylinder Head: Camshaft(S): Removal: Camshaft

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Valvetrain
GC0015291Courtesy of CHRYSLER LLC
  1. Remove the primary timing chain. See REMOVAL .
  2. Remove secondary chain tensioner (6) mounting bolts.
    NOTE: Camshaft bearing caps have been marked during engine manufacturing. For example, number one exhaust camshaft bearing is marked "1E".
    Fig 2: Removing Cam Bearing Cap
    GC0015277Courtesy of CHRYSLER LLC
  3. Slowly loosen camshaft bearing cap bolts in the order shown in illustration.
    Fig 3: Valvetrain
    GC0015291Courtesy of CHRYSLER LLC
  4. Remove camshaft bearing caps (1).
  5. Remove intake camshaft (7), exhaust camshaft (2), secondary timing chain (8), and secondary timing chain tensioner (6) together as an assembly.
  6. Remove secondary timing chain tensioner (6) and secondary timing chain (8) from camshafts (2)&(7).
  7. Inspect camshafts. See INSPECTION .
scientia non olet · About LEMON Manuals