LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine & Automatic Transmission Cooling System) >> Transmission >> Transmission Cooler Lines >> Installation

Transmission Cooler Lines: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install rear transmission cooler lines at transmission. Tighten fittings to 20 N.m (18 ft. lbs.).
  2. Install rear transmission cooler lines to thermal bypass valve. Tighten fittings to 20 N.m (18 ft. lbs.).
  3. Install front transmission cooler lines to thermal bypass valve. Tighten fittings to 20 N.m (18 ft. lbs.).
  4. Install front transmission cooler lines into transmission cooler (Refer to COOLING/TRANSMISSION - STANDARD PROCEDURE) .
  5. Lower vehicle.
  6. Check transmission fluid level (Refer to STANDARD PROCEDURE ).
scientia non olet · About LEMON Manuals