LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine & Automatic Transmission Cooling System) >> Engine >> Water Pump >> Removal >> 3.0L Diesel

3.0L Diesel

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: 3.0L WATER PUMP
GC0039782Courtesy of DAIMLERCHRYSLER CORP.
WARNING: Risk of injury to skin and eyes from scalding with hot coolant. Risk of poisoning from swallowing coolant. Do not open cooling system unless coolant temperature is below 90°C (194°F). Open cap slowly to release pressure. Store coolant in suitable and appropriately marked container. Wear protective gloves, clothes and eye wear.
  1. Disconnect negative battery cable.
  2. Remove engine cover.
  3. Drain engine coolant (Refer to COOLING - STANDARD PROCEDURE) .
  4. Remove accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) 
  5. Disconnect coolant hoses at water pump.
  6. Remove idler pulley (Refer to COOLING/ACCESSORY DRIVE/IDLER PULLEY - REMOVAL) .
  7. Remove water pump and clean sealing surfaces.