3.0L Diesel
WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Clean all sealing surfaces.
- Position and install water pump. Tighten M6 bolts to 14 N.m (124 lbs. in.) and M8 bolts to 20 N.m (177 lbs. in.).
- Install idler pulley. Tighten bolt to 35 N.m (26 lbs. ft.).
- Install coolant hoses.
- Install accessory drive belt (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - INSTALLATION) .
- Close coolant drain.
- Install engine cover.
- Connect negative battery cable.
- Fill coolant system to proper level with the appropriate coolant mixture. Refer to STANDARD PROCEDURE WARNING: Use extreme caution when engine is operating. Do not put your hands near pulleys, belts or fan. Do not wear loose clothes.
- Start engine and inspect for leaks.