LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine & Automatic Transmission Cooling System) >> Engine >> Engine Coolant Thermostat >> Removal >> 3.0L Diesel

3.0L Diesel

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Risk of injury to skin and eyes from scalding with hot coolant. Risk of poisoning from swallowing coolant. Do not open cooling system unless coolant temperature is below 90° C (194° F). Open cap slowly to release pressure. Store coolant in suitable and appropriately marked container. Wear protective gloves, clothes and eye wear.
NOTE: Inspect condition of all clamps and hoses, replace as necessary.
  1. Disconnect negative battery cable.
  2. Remove engine cover.
  3. Drain engine coolant. (Refer to STANDARD PROCEDURE ).
  4. Remove bracket for fuel line.
  5. Remove coolant hoses and thermostat housing.
  6. Remove thermostat housing.
  7. Clean all sealing surfaces.
scientia non olet · About LEMON Manuals