LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine & Automatic Transmission Cooling System) >> Engine >> Engine Coolant Thermostat >> Operation >> Gas Engine >> 3.0L Diesel Engine

3.0L Diesel Engine

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

WARM-UP PHASE 

Fig 1: WARM-UP PHASE
GC0039778Courtesy of DAIMLERCHRYSLER CORP.

Up to a coolant temperature of approximately 87° C (189° F), the main valve is closed and the bypass valve fully open. The flow through the radiator is interrupted and coolant flows through the bypass passage directly to the inlet side of the water pump.

PARTIAL-LOAD PHASE 

Fig 2: PARTIAL-LOAD PHASE
GC0039779Courtesy of DAIMLERCHRYSLER CORP.

The main valve begins to open at a coolant temperature of 86° C (189° F), and a small amount of coolant flows through the radiator. As the engine temperature increases, the main valve opens further and the bypass valve gradually closes. More coolant flows through the radiator and less coolant flows through the bypass passage.

FULL-LOAD PHASE 

Fig 3: FULL-LOAD PHASE
GC0039777Courtesy of DAIMLERCHRYSLER CORP.

The main valve is fully open at a coolant temperature above 102° C (216° F). The bypass plate seals off the bypass passage. The entire quantity of coolant flows through the radiator.