LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine & Automatic Transmission Cooling System) >> Engine >> Engine Coolant Thermostat >> Installation >> 3.0L Diesel

3.0L Diesel

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean all sealing surfaces.
  2. Position and install thermostat housing Tighten bolts to 9 N.m (80 lbs.in.).
    NOTE: Inspect condition of all clamps and hoses, replace as necessary.
  3. Connect coolant hoses,
  4. Install bracket for fuel line.
  5. Close coolant drain.
  6. Install engine cover.
  7. Connect negative battery cable.
  8. Fill coolant system to proper level with appropriate coolant mixture. (Refer to STANDARD PROCEDURE ).
    WARNING: Use extreme caution when engine is operating. Do not stand in direct line with fan. Do not put your hands near pulleys, belts or fan. Do not wear loose clothes.
  9. Start engine and inspect for leaks.
scientia non olet · About LEMON Manuals