LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (Engine & Automatic Transmission Cooling System) >> Engine >> Engine Coolant Temp Sensor >> Removal >> 3.0L Diesel

3.0L Diesel

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Remove/Install ETC 3.0L
GC0039774Courtesy of DAIMLERCHRYSLER CORP.
WARNING: Risk of injury to skin and eyes from scalding with hot coolant. Risk of poisoning from swallowing coolant. Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly to release pressure. Store coolant in suitable and appropriately marked container. Wear protective gloves, clothes and eye wear.
  1. Disconnect negative battery cable.
  2. Remove engine cover.
  3. Partially drain coolant system (Refer to COOLING - STANDARD PROCEDURE) .
  4. Unplug coolant temperature sensor electrical connector.
    NOTE: Capture any residual coolant that may flow.
  5. Remove coolant temperature sensor (2).