LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Anti-Lock Brake System & Adjustable Pedals - Electrical Diagnostics) >> Electrical Diagnostics >> Abs >> DTC Troubleshooting >> U0101-Lost Communication With TCM >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. VERIFY DTC IS ACTIVE 
    NOTE: Verify the IOD fuse is installed and battery voltage is between 10 and 16 volts before proceeding.
    NOTE: If present, diagnose and repair DTC U0002-CAN C BUS OFF PERFORMANCE, DTC U0146-LOST COMMUNICATION WITH CENTRAL GATEWAY, or DTC U1502-IMPLAUSIBLE MESSAGE DATA LENGTH RECEIVED FROM TIPM before diagnosing this DTC.

    Turn the ignition on.

    With the scan tool, read and record ABS DTCs.

    With the scan tool, read and record Environmental Data (EV Data).

    With the scan tool, erase ABS DTCs.

    Cycle the ignition switch.

    With the scan tool, read ABS DTCs.

    Does this DTC reset? 

    Yes 

    1. Go To  2.

    No 

    1. Perform the Stored Lost Communication test procedure. Refer to DIAGNOSIS AND TESTING .
    2. Perform BODY VERIFICATION TEST - VER 1 .
  2. CHECK FOR ANY OF THE FOLLOWING ACTIVE DTCs 

    With the scan tool, read all active DTCs from all CAN C Bus modules.

    NOTE: Check for CAN C hardware electrical, VIN Missing/Mismatch, battery or ignition related DTCs.

    Does the scan tool display any active DTCs related to the conditions listed above? 

    Yes 

    1. Diagnose and repair the DTC(s). Refer to appropriate ELECTRICAL DIAGNOSTICS article .

    No 

    1. Go To  3.
  3. VERIFY THAT THE TCM IS ACTIVE ON THE BUS 

    With the scan tool, select ECU View.

    Verify that the TCM is active on the bus.

    Is the TCM active on the bus? 

    Yes 

    1. Go To  4.

    No 

    1. Refer to appropriate ELECTRICAL DIAGNOSTICS article for a NO RESPONSE test procedure.
    2. Perform BODY VERIFICATION TEST - VER 1 .
  4. CHECK FOR ADDITIONAL COMMUNICATION RELATED DTCs 

    With the scan tool, select Network View and select Advanced.

    Is there more than one module with active DTCs "Logged Against" the TCM? 

    Yes 

    1. Replace/update the TCM in accordance with the service information.
    2. Perform BODY VERIFICATION TEST - VER 1 .

    No 

    1. Replace the Anti-Lock Brakes Module in accordance with the service information.
    2. Perform ABS VERIFICATION TEST .
scientia non olet · About LEMON Manuals