LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Anti-Lock Brake System & Adjustable Pedals - Electrical Diagnostics) >> Electrical Diagnostics >> Abs >> DTC Troubleshooting >> C2204-Dynamics Sensor Internal >> Monitor Conditions

Monitor Conditions

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. When Monitored: 

    Continuously, with ignition on, but not if the sensor voltage is out of range.

    Or, during diagnostic mode.

    Or, if the monitoring was inhibited by a corresponding diagnostics command.

    Or, if the vehicle speed has exceeded 20 km/h (12.4 m.p.h.) during the actual ignition cycle.

    Or, if at least one over spinning wheel is detected.

    Or, if one of the control functions is active.

scientia non olet · About LEMON Manuals