Diagnostic Test
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- VERIFY DTC IS ACTIVE
Turn the ignition on.
With the scan tool, read and record ABS DTCs.
With the scan tool, read and record Environmental Data (EV Data).
With the scan tool, erase ABS DTCs.
Cycle the ignition switch.
WARNING: Ensure brake capability is available before road testing.Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 10 and 20 km/h (6 and 12 mph).
Park the vehicle.
With the scan tool, read ABS DTCs.
Does this DTC reset?
Yes
- Go To 2.
No
- Refer to the ABS INTERMITTENT CONDITION diagnostic procedure.
- CHECK THE DYNAMICS SENSOR INSTALLATION NOTE: Dynamics Sensor installation and mounting bolt torque is crucial for proper operation.
Turn the ignition off.
Check the Dynamics Sensor for damage.
Check the Dynamics Sensor mounting bolts for a loose or over tightened condition. Refer to C123C-DYNAMICS SENSOR MOUNTING/INSTALLATION PERFORMANCE .
Were any problems found?
Yes
- Repair as necessary.
- Perform ABS VERIFICATION TEST .
No
- Replace the Dynamics Sensor in accordance with the Service Information.
- Perform ABS VERIFICATION TEST .