Diagnostic Test
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- PERFORM ECU INITIALIZATION
Turn the ignition on.
With the scan tool, erase ABS DTCs.
Cycle the ignition switch.
WARNING: To avoid personal injury or death, check brake capability is available before road testing.Perform ECU initialization with drive test. Perform ABS VERIFICATION TEST .
NOTE: The ECU Initialization process must include driving the vehicle into a 90° turn.Park the vehicle.
- Go To 2.
- VERIFY IF DTC IS STILL ACTIVE
Cycle the ignition switch.
WARNING: To avoid personal injury or death, check brake capability is available before road testing.Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 10 and 25 km/h (6 and 15 mph).
Park the vehicle.
With the scan tool, read ABS DTCs.
Does this DTC reset?
Yes
- Replace the Dynamics Sensor or Anti-Lock Brake Module in accordance with the Service Information.
- Perform ABS VERIFICATION TEST .
NOTE: Vehicles without a Dynamics Sensor replace Anti-Lock Brake Module.No
- Refer to the ABS INTERMITTENT CONDITION diagnostic procedure.