Diagnostic Test
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK FOR A DTC C121E-BRAKE PRESSURE SENSOR COMPARATIVE PERFORMANCE NOTE: This DTC must be active for the results of this test to be valid.
Turn the ignition on.
With the scan tool, read and record DTCs.
With the scan tool, read and record Freeze Frame information.
With the scan tool, erase DTCs.
Start the engine.
Slowly depress and release the brake pedal.
With the scan tool, read and record DTCs.
Does the scan tool display: C121E-BRAKE PRESSURE SENSOR COMPARATIVE PERFORMANCE?
Yes
- Go To 2.
No
- Refer to the ABS INTERMITTENT CONDITION diagnostic procedure.
- HCU/ECU ISOLATION
Turn the ignition off.
Separate the ECU from the HCU.
With the scan tool, monitor brake pressure.
Does the scan tool display brake pressure above 218 bar (3162 psi)?
Yes
- Replace the HCU in accordance with the Service Information.
- Perform ABS VERIFICATION TEST .
No
- Replace the ECU in accordance with the Service Information.
- Perform ABS VERIFICATION TEST .