LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 237 (Anti-Lock Brake System & Adjustable Pedals - Electrical Diagnostics) >> Electrical Diagnostics >> Abs >> DTC Troubleshooting >> C107C-Brake Pedal Switch 1/2 Stuck-Gas >> Diagnostic Test

Diagnostic Test

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. ENGINE DTCS PRESENT 

    With the scan tool, read Engine DTCs.

    Are there any Engine DTCs present? 

    Yes 

    1. Refer to appropriate Engine ELECTRICAL DIAGNOSTICS article and perform the appropriate diagnostic procedure.

    No 

    1. Using the schematics as a guide, check the Powertrain Control Module (PCM) terminals for corrosion, damage, or terminal push out. Pay particular attention to all power and ground circuits.
    2. Perform *PCM VERIFICATION TEST .