LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 236 (Wiper System & Washer System (Service Information)) >> Wipers/Washers - Service Information >> Module-Front Wiper >> Removal >> Module-Front Wiper

Module-Front Wiper

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Front Wiper Arms
GC0016715Courtesy of CHRYSLER LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the wiper arms (1) and (2). See REMOVAL .
    Fig 2: Removing/Installing Cowl Panel
    GC0013423Courtesy of CHRYSLER LLC
  3. Remove the cowl panel (1). Refer to REMOVAL .
    Fig 3: Wiper Motor Electrical Connector
    GC0016714Courtesy of CHRYSLER LLC
  4. Disconnect the wiper motor electrical connector (1).
    Fig 4: Removing/Installing Wiper Module
    GC0016710Courtesy of CHRYSLER LLC
  5. Remove the two retaining bolts (1 and 4) and remove wiper module (3) from vehicle.
scientia non olet · About LEMON Manuals