Oil Change Indicator - Reset

Your vehicle is equipped with an engine oil change indicator system. The "Oil Change Required" message will flash in the EVIC display for approximately 10 seconds after a single chime has sounded to indicate the next scheduled oil change interval. The engine oil change indicator system is duty cycle based, which means the engine oil change interval may fluctuate dependent upon your personal driving style.

Unless reset, this message will continue to display each time you turn the ignition switch to the ON/RUN position. To turn off the message temporarily, press and release the Menu button. To reset the oil change indicator system (after performing the scheduled maintenance) perform the following procedure:

1. Turn the ignition switch to the "ON" position (Do not start the engine).
2. Fully depress the accelerator pedal slowly three times within 10 seconds.
3. Turn the ignition switch to the "LOCK" position.

At Each Stop for Fuel

1. Check the engine oil level.
2. Check the windshield washer solvent and add if required.

Once a Month

1. Check tire pressure and look for unusual wear or damage.
2. Inspect the battery, and clean and tighten the terminals as required.
3. Check the fluid levels of coolant reservoir, brake master cylinder, power steering, and transmission, and add as needed.
4. Check all lights and other electrical items for correct operation.

At Each Oil Change

1. Change the engine oil filter.
2. Inspect the brake hoses and lines.