Propeller Shaft - Front

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Heat Shield

Courtesy of CHRYSLER LLC

1 - HEAT SHIELD

Place gearshift lever in NEUTRAL and raise vehicle on hoist.
Remove propeller shaft heat shield.

Fig 2: Removing/Installing Front Propeller Shaft
Courtesy of CHRYSLER LLC

1 - PROPELLER SHAFT ASSEMBLY

2 - BOLTS
Apply alignment index marks on the propeller shaft and front axle flanges.
Remove and discard four front propeller shaft-to-axle flange bolts (2).
Apply alignment index marks on the propeller shaft and transfer case flanges.
Remove and discard four front propeller shaft-to-transfer case flange bolts (2).
Remove propeller shaft assembly (1).