LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 233 (Differential & Driveline) >> Rear Axle - 210RII >> Seal-Axle Shaft >> Installation >> Axle Shaft Seals (210 Axle)

Axle Shaft Seals (210 Axle)

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Axle Seal Installation
GC0014184Courtesy of CHRYSLER LLC
  1. Using Installer 9223 (2), install NEW  axle shaft seal (1). Lubricate the inside diameter with Mopar® Gear and Axle Lubricant 75W-140 to protect seal during halfshaft installation.
  2. Install halfshaft(s). See INSTALLATION .
    Fig 2: Rear Axle Fill Plug
    GC0014183Courtesy of CHRYSLER LLC
  3. Remove fill plug (1) to check and adjust rear axle fluid level. Top off axle with Mopar® Gear and Axle Lubricant 75W-140. Reinstall fill plug and torque to 50 N.m (37 ft. lbs.) torque.
scientia non olet · About LEMON Manuals