210 Mm Differential

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If replacement differential side bearings or differential case are being installed, it is necessary to measure and adjust Differential Side Bearing Preload and Gear Backlash. Refer to ADJUSTMENTS - SIDE BEARING PRELOAD AND GEAR BACKLASH (210) to determine proper snap ring selection.

Fig 1: Removing/Installing Differential

Courtesy of CHRYSLER LLC

Install differential assembly (1) into axle housing. Note: If difficulty installing differential is encountered due to interference with spreader and plates, remove axle housing from spreader, plates from housing, and install differential. Return assembly to the spreader.

Fig 2: Removing/Installing Side Bearing Cups
Courtesy of CHRYSLER LLC
Install differential side bearing cups (2). Use Removal/Installation Arbor 9522 (1) to aid in differential alignment.

Fig 3: Seating Side Bearing Cups Using Removal/Installation Arbor 9522
Courtesy of CHRYSLER LLC
Use Removal/Installation Arbor 9522 (1) to aid in seating side bearing cups (2).

Fig 4: Measuring Carrier Spread
Courtesy of CHRYSLER LLC
Set up Dial Indicator Set C-3339-A to measure housing spread as shown:
- Clamp SP-5426 (1)
- Post SP-5425-B (2)
- Metric Dial Indicator 9524 (3)
Fig 5: Expanding/Contracting W-129-B Spreader
Courtesy of CHRYSLER LLC
Expand Spreader W-129-B (1) to spread axle housing no more than 0.30 mm (0.012 in.).
NOTE: The differential side bearing snap rings are select-fit, and control ring gear backlash and differential side bearing preload. It is necessary to return snap rings to their original position. If replacement differential side bearings, differential case, or axle housing are being installed, refer to ADJUSTMENTS - SIDE BEARING PRELOAD AND GEAR BACKLASH (210) to determine proper snap ring selection.

Fig 6: Snap Ring Removal/Installation
Courtesy of CHRYSLER LLC
Using suitable snap ring pliers (2), install differential side bearing snap rings (1).

Fig 7: Expanding/Contracting W-129-B Spreader
Courtesy of CHRYSLER LLC
Back off Spreader W-129-B (1) to relax tension on housing.

Fig 8: Spreader Adapters 9226
Courtesy of CHRYSLER LLC
Remove axle assembly from spreader. Remove plates (1).

Fig 9: Sealant Application
Courtesy of CHRYSLER LLC
Apply 4mm (0.157 in.) bead (2) of Mopar® Axle RTV to axle housing cover (1) as shown.

Fig 10: 210 Axle Housing Cover & Bolts
Courtesy of CHRYSLER LLC
Install cover (2) to axle housing. Install and torque cover-to-housing bolts (1) to 30 N.m (22 ft. lbs.) + 45°.

Fig 11: Axle Seal Installation
Courtesy of CHRYSLER LLC
Install axle seals (1) using Installer 9223 (2).