Pinion Seal/Flange

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Measuring Rotating Torque

Courtesy of CHRYSLER LLC

Remove rear axle assembly from vehicle. Refer to REMOVAL .
Measure axle assembly rotating torque and record measurement for reuse on assembly.

Fig 2: Pinion Flange Nut Removal/Installation
Courtesy of CHRYSLER LLC
Using Flange Wrench C-3281(1) and 41mm socket, remove pinion flange nut and discard.

Fig 3: Removing Pinion Flange With Puller 1026
Courtesy of CHRYSLER LLC

NOTE: Due to axle imbalance concerns, it is necessary to make sure pinion flange-to-shaft orientation is maintained. If alignment marks are not visible, apply appropriate marks before removing pinion flange.
Using Puller 1026 (1), remove pinion flange (2) from pinion shaft.

Fig 4: Removing/Installing Pinion Seal
Courtesy of CHRYSLER LLC
Using suitable tool (1), remove pinion seal (2) and discard.