Differential/Ring Gear Assembly

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Pinion Shaft

Courtesy of CHRYSLER LLC

Install pinion shaft (1), pinion gears (3) and thrust washers (2). See Fig 1.

Fig 2: Pinion Shaft Roll Pin
Courtesy of CHRYSLER LLC
Using suitable punch, install new roll pin and install flush to differential case (1).

Fig 3: Side Gear & Washer
Courtesy of CHRYSLER LLC
Install differential side gears (2) and thrust washers (1). Rotate into position.

Fig 4: Installing Differential Side Bearing (Ring Gear Side)
Courtesy of CHRYSLER LLC
Using Installer 9666 (1), install new differential side bearing (ring gear side).

Fig 5: Installing Differential Side Bearing
Courtesy of CHRYSLER LLC
Using Installer 9665 (1), install new differential side bearing (opposite side).