Sensor - Inlet Air Temperature - 6.1L

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: IAT Sensor Location - 6.1L

Courtesy of CHRYSLER LLC

The Inlet Manifold Air Temperature (IAT) sensor (1) is installed into the rubber air intake hose (2) near front of throttle body.

Fig 2: Remove/Install IAT Sensor - 6.1L

Courtesy of CHRYSLER LLC

Pull sensor from rubber hose.
Disconnect electrical connector (1) from IAT sensor (2).
Check sensor probe (3) for damage.
Clean dirt from sensor base.