Body - Throttle - 6.1L

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Throttle Body R/I- 6.1L

Courtesy of CHRYSLER LLC

CAUTION: Do not use spray (carb) cleaners on any part of the throttle body. Do not apply silicone lubricants to any part of the throttle body.

Remove rubber air duct at front of throttle body.
Disconnect electrical connector (2) at throttle body (1).
Remove four throttle body mounting bolts (3).
Remove throttle body from intake manifold.

Fig 2: Throttle Body O-Ring - 6.1L
Courtesy of CHRYSLER LLC
Check condition of throttle body o-ring (2) at front of intake manifold (1).