Crankshaft Position Sensor

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locating Crankshaft Position Sensor

Courtesy of CHRYSLER LLC

1 - HEAT SHIELD

2 - CRANKSHAFT POSITION SENSOR

Disconnect the negative battery cable.
Raise and support the vehicle.
Remove the crankshaft position sensor heat shield (1). See Fig 1.
Disconnect the crankshaft sensor wiring harness connector.
Remove the bolt and sensor (2).