Tube - Fuel Tank Filler

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Filler Tube Assembly

Courtesy of CHRYSLER LLC

Disconnect negative battery cable.
Drain fuel from tank.
Fuel filler tube assembly.

Fig 2: Filler Tube Door
Courtesy of CHRYSLER LLC
Open filler tube door.

Fig 3: Removing/Installing Retaining Wire
Courtesy of CHRYSLER LLC
Remove retaining wire from inside filler tube rubber.

Fig 4: Pushing Rubber Back
Courtesy of CHRYSLER LLC
Start removing rubber from body sheet metal.

Fig 5: Squeezing Rubber & Pushing In
Courtesy of CHRYSLER LLC
Squeeze rubber and push in.

Fig 6: Filler Tube Rubber At Body Opening
Courtesy of CHRYSLER LLC
Filler tube and rubber removed from body sheet metal.

Fig 7: Locating Inner Splash Shield
Courtesy of CHRYSLER LLC
Raise vehicle and support.
Remove the left rear tire.
Remove the left inner splash shield.

Fig 8: Disconnect/Connect Filler Tube Vent Line
Courtesy of CHRYSLER LLC
Disconnect the filler tube vent line.

Fig 9: Filler Tube Mounting Screw
Courtesy of CHRYSLER LLC
Remove the filler tube mounting bolt.

Fig 10: Splash Shield Driver Side
Courtesy of CHRYSLER LLC
Remove the under body splash shield.

Fig 11: Filler Tube
Courtesy of CHRYSLER LLC
Loosen the filler tube hose clamp. Leave the clamp tight on the hose and fuel tank location.

Fig 12: Removing Rubber at Tank
Courtesy of CHRYSLER LLC
Move clamp toward the fuel tank.

Fig 13: Remove/Install Filler Tube
Courtesy of CHRYSLER LLC
Remove the filler tube assembly from the vehicle.