LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 230 (Fuel System) >> Fuel Delivery - Diesel >> Sensor-Water In Fuel >> Removal >> Water In Fuel Sensor

Water In Fuel Sensor

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the engine cover.
    NOTE: Capture and store any fuel spillage in appropriate containers
  3. Disconnect the water in fuel (WIF) electrical connector.
  4. Remove the WIF sensor retaining screws.
  5. Twist the WIF sensor so the tabs clear the retaining bracket.
  6. Gently pry up on the sensor and remove.
scientia non olet · About LEMON Manuals