Cushion/Cover-Cushion - Second Row: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Cushion Support

Courtesy of DAIMLERCHRYSLER CORP.

Install hog rings attaching cushion support, if remove.

Fig 2: Rear Seat Cushion Hog Rings (1)
Courtesy of DAIMLERCHRYSLER CORP.
Place seat cover into position on the foam.
Install the attaching hog rings on the inner side of the seat cover and cushion.

Fig 3: Rear Seat Cushion Hog Rings (2)
Courtesy of DAIMLERCHRYSLER CORP.
Install hog rings on the on the front side the seat cover.

Fig 4: Rear Seat Cushion Hog Rings (3)
Courtesy of DAIMLERCHRYSLER CORP.
Install hog rings on the outer side of the seat cover. Check for seat cover wrinkles.

Fig 5: Rear Seat Cushion Hog Rings (4)
Courtesy of DAIMLERCHRYSLER CORP.
Install the hog rings on the rear side of seat cover.
Repeat the operation for the other side of cushion.

Fig 6: Move Seat Cover to Access Hog Rings
Courtesy of DAIMLERCHRYSLER CORP.
Position seat cover in to position on the foam and check for seat cover wrinkles.

Fig 7: Connect J-Straps
Courtesy of DAIMLERCHRYSLER CORP.
Connect the J-straps, and smooth out seat cover.
Steam wrinkles from seat cushion, if necessary.

Fig 8: Rear Seat Cushion
Courtesy of DAIMLERCHRYSLER CORP.
Place seat cushion (4) into position.
Engage retainer loops into cup on floor kick up.
Push downward at forward edge at each retainer loop of the rear seat cushion to engage retainers.