LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Body - Interior & Exterior) >> Seats >> Cushion/Cover-Cushion - Front >> Installation

Cushion/Cover-Cushion - Front: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Zip Strip
GC0013546Courtesy of DAIMLERCHRYSLER CORP.
  1. Before proceeding with the following repair procedure, review all warnings and cautions. (Refer to BODY/SEATS - WARNING) 
  2. Position the cushion cover and foam over the seat pan and connect the j-straps (1 & 2).
    Fig 2: Cushion Nuts
    GC0013545Courtesy of DAIMLERCHRYSLER CORP.
  3. Position the seat cushion assembly onto the seat frame and install the clamps (1).
  4. Connect the wire harness to the seat cushion pan, if equipped.
  5. Install the bolts (2) and tighten to 10 N.m (90 in. lbs.).
  6. Connect battery negative cable.
scientia non olet · About LEMON Manuals