LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Body - Interior & Exterior) >> Rear Door >> Glass Run Channel >> Removal

Glass Run Channel: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Door Glass Channel And Bracket
GC0013400Courtesy of DAIMLERCHRYSLER CORP.
  1. Remove the trim panel from the inside of the rear door. (Refer to BODY/DOOR - REAR/TRIM PANEL - REMOVAL) .
  2. Remove the watershield from the inside of the rear door. (Refer to BODY/DOOR - REAR/WATERSHIELD - REMOVAL) .
  3. Loosen the two screws (1) that secure the rear door glass channel and bracket (2) to the inside of the rear door.
  4. Disengage the two screws from the keyed holes near the back of the inner door panel and remove the channel and bracket from the interior of the rear door.
scientia non olet · About LEMON Manuals