LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 23 (Body - Interior & Exterior) >> Interior >> Rear Shelf Trim Panel >> Removal

Rear Shelf Trim Panel: Removal

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Shelf Trim Panel
GC0013523Courtesy of DAIMLERCHRYSLER CORP.
  1. Disconnect and isolate the battery negative cable.
  2. Remove the right and left lower and upper C-pillar trim from the vehicle. (Refer to BODY/INTERIOR/C-PILLAR TRIM - REMOVAL) .
  3. Remove the nut that secures the center rear seat belt lower anchor to the stud on the floor panel and feed the seat belt webbing back through the opening in the top of the rear shelf panel trim (2) to the retractor.
  4. Remove the push-pin fastener (1) that secures the trim to the rear shelf panel (3).
  5. Slide the trim forward to disengage the S-clip that secures the underside of the trim to the center of the shelf panel.
  6. Remove the trim from the rear shelf panel.
scientia non olet · About LEMON Manuals