Bin-Glove Box: Installation

WARNING: This page is about a different car, the 2006 Dodge Magnum, 2006 Dodge Charger, and 2006 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Bin-Glove Box Support Strap

Courtesy of DAIMLERCHRYSLER CORP.

Position the glove box bin (1) into the vehicle.
Turn the glove box bin sideways and install the support strap and retainer assembly (2) onto the outboard end of the bin.

Fig 2: Bin-Glove Box R and I
Courtesy of DAIMLERCHRYSLER CORP.
Engage the glove box bin hinge hooks (3) onto the instrument panel hinge brackets (4) located at each end of the glove box bin (1) and pivot the bin upward.
To engage the glove box stops (2), push inward on both sides of the glove box bin and pivot the bin into the instrument panel.
Close the glove box bin.