LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Engine & Automatic Transmission Cooling System) >> Engine >> Thermostat-Engine Coolant >> Removal >> Removal-3.0L Diesel

Removal-3.0L Diesel

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Risk of injury to skin and eyes from scalding with hot coolant. Risk of poisoning from swallowing coolant. Do not open cooling system unless coolant temperature is below 90° C (194° F). Open cap slowly to release pressure. Store coolant in suitable and appropriately marked container. Wear protective gloves, clothes and eye wear.
NOTE: Inspect condition of all clamps and hoses, replace as necessary.
  1. Disconnect negative battery cable.
  2. Remove engine cover.
  3. Drain engine coolant. See STANDARD PROCEDURE .
  4. Remove bracket for fuel line.
  5. Remove coolant hoses and thermostat housing.
  6. Remove thermostat housing.
  7. Clean all sealing surfaces.
scientia non olet · About LEMON Manuals