LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Engine & Automatic Transmission Cooling System) >> Engine >> Thermostat-Engine Coolant >> Removal >> 2.7L Engine

2.7L Engine

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect negative cable.
    2. Fig 1: Accessory Belts
    G00563593Courtesy of DAIMLERCHRYSLER CORP.
  2. Remove accessory drive belts (6). Refer to (Refer to COOLING/ACCESSORY DRIVE/DRIVE BELTS - REMOVAL) .
  3. Raise and support vehicle.
  4. Remove left front wheel.
    5. Fig 2: Engine Splash Shield
    G00563594Courtesy of DAIMLERCHRYSLER CORP.
  5. Remove the lower engine splash shield (2).
  6. Drain cooling system STANDARD PROCEDURE .
    7. Fig 3: A/C Compressor Removel/Installation
    G00563595Courtesy of DAIMLERCHRYSLER CORP.
  7. Remove the A/C compressor bolts (1).
  8. Position the A/C compressor (3) aside.
    9. Fig 4: Heater Line and Thermostat Housing
    G00563596Courtesy of DAIMLERCHRYSLER CORP.
  9. Remove the nuts (4) that secure the heater line (3) to the thermostat housing and position aside.
  10. Remove the upper thermostat housing bolt (2).
  11. Remove the lower thermostat housing studs (5).
  12. Remove thermostat and housing (1).
  13. Remove the hose from the thermostat housing.
scientia non olet · About LEMON Manuals