Sensor-Engine Coolant Temperature: Removal: Removal-2.7L
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
| 1 - ENGINE COOLANT SENSOR |
| 2 - ELECTRICAL CONNECTOR |
| 3 - COOLANT OUTLET TUBE |
- Disconnect negative battery cable.
- Partially drain cooling system. See STANDARD PROCEDURE .
- Disconnect the electrical connector (2).
- Remove engine coolant sensor (1) from coolant outlet tube (3).