Section 227 (Engine & Automatic Transmission Cooling System): Engine: Pump-Water: Removal: Removal-3.5L

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Water Pump - 3.5L

Courtesy of CHRYSLER LLC

1 - SCREWS

2 - WATER PUMP BODY

The water pump on all models can be replaced without discharging the air conditioning system.

WARNING: Do not remove pressure cap with the system hot and under pressure because serious burns from coolant can occur.

Drain cooling system. See STANDARD PROCEDURE .
Remove accessory drive belts. See REMOVAL .
NOTE: The water pump is driven by the timing belt.
Remove engine timing belt. Refer to REMOVAL .
Remove water pump mounting bolts (1). Note position of longer bolts for proper re-installation.
Remove water pump body (2) from engine.