LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 227 (Engine & Automatic Transmission Cooling System) >> Engine >> Pump-Water >> Removal >> Removal-3.0L Diesel

Removal-3.0L Diesel

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Water Pump - 3.0L
GC0039782Courtesy of CHRYSLER LLC
WARNING: Risk of injury to skin and eyes from scalding with hot coolant. Risk of poisoning from swallowing coolant. Do not open cooling system unless coolant temperature is below 90°C (194°F). Open cap slowly to release pressure. Store coolant in suitable and appropriately marked container. Wear protective gloves, clothes and eye wear.
  1. Disconnect negative battery cable.
  2. Remove engine cover.
  3. Drain engine coolant. See STANDARD PROCEDURE .
  4. Remove accessory drive belt. See REMOVAL .
  5. Disconnect coolant hoses at water pump.
  6. Remove idler pulley. See REMOVAL .
  7. Remove water pump and clean sealing surfaces.
scientia non olet · About LEMON Manuals