Liftgate Lower Trim Panel
WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect and isolate the battery negative cable.
- Remove the lamp from the lower liftgate trim panel.
- Remove the two screws (6) within the pull cup formation to the right of the latch that secure the lower trim panel (1) to the inside of the liftgate (4).
- Using a trim stick or another suitable wide flat-bladed tool, carefully pry the trim panel away from the inside of the liftgate to release the seven push-in plastic fasteners (7) that secure the panel to the liftgate.
- Remove the liftgate lower trim panel from the vehicle.