LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2009 >> 300 Signature Series >> Repair and Diagnosis >> External Pages >> Different car >> Section 226 (Body - Interior & Exterior) >> Interior >> Carpet >> Removal >> Removal-Rear

Section 226 (Body - Interior & Exterior): Interior: Carpet: Removal: Removal-Rear

WARNING: This page is about a different car, the 2008 Dodge Magnum, 2008 Dodge Charger, and 2008 Chrysler 300. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Carpet
GC0013506Courtesy of CHRYSLER LLC
  1. Remove the driver and passenger front seats from the vehicle. See REMOVAL .
  2. Remove the center console from the front floor panel transmission tunnel. See REMOVAL .
  3. Remove the trim from the inside of both lower B-pillars. See REMOVAL .
  4. Remove the rear seat cushion from the vehicle. See REMOVAL .
  5. Remove the scuff plate from both rear door sills. See REMOVAL .
  6. Remove the push-pin fasteners (2) that secure the outboard edges of the rear carpet (3) near the front of each rear door opening (1) sill.
  7. Lift the rear carpet from the floor panel far enough to extract the body wire harness take outs and connectors through the appropriate slits in the carpeting.
  8. Remove the rear carpet from the vehicle through one of the rear door openings.
scientia non olet · About LEMON Manuals